Arcade Collecting > Merit/JVL Touchscreen

ML-1 discussion thread

<< < (6/11) > >>

mahkeymike:

--- Quote from: pivheng on April 26, 2014, 03:48:12 pm ---Now i managed to clone the ML-1 drive without any error but when i take the clone drive and plug it in the ML-1 game. During the boot up the ML-1 rendering the new hard drive and it loading to 98% then a screen pop up with errors.  :banghead: :banghead: :banghead:

--- End quote ---

What do the errors say?

pivheng:
Here are the screenshot.

http://postimg.org/image/lf7gkuysp/

http://postimg.org/image/rsoubnihx/

http://postimg.org/image/e8lzzkdwx/

 :hissy: :hissy: :hissy:

mahkeymike:
I need to see  rest of the JIT debugging message in that last pic. Its possible that #1. they put hard drive checks back into there software. Or #2 some files got corrupted during cloneing.(rare but possible). Theres a few ways you could go about this. #1. try and clone it again. #2. Get a exact size/model hard drive and swap the circuit board on the bottom of the drive. (be very careful doing this) If you try the second option it will prove if theres hard drive checking in place or not. Also will prove if the cloneing was sucessful.

ed12:
/r=root dose it not ?

ed

smartbomb2084:
According to merit tech support a cloned ML-1 hard drive won't work in the game... Now they could be just saying that to discourage copying but after reading this thread it may be true... :dunno

Navigation

[0] Message Index

[#] Next page

[*] Previous page