| Main > Main Forum |
| Button recommendations? |
| << < (2/3) > >> |
| PL1:
--- Quote from: DeLuSioNal29 on April 15, 2014, 04:32:52 pm ---To get the 30mm buttons in you need to drill a 30mm hole halfway from the top until only the center of the drill bit pops out of the bottom. Then you flip it over and drill from the bottom with a larger bit (lining up the drill bit with the center of the hole). (I can't recall what size the bigger drill bit is, but I'll look when I get home). This allows the button to be placed on the top and the larger ring to be screwed on from the bottom. --- End quote --- The threaded ring (nut) on the OBSN is 1.415" diameter and 0.43" thick. The maximum panel thickness you can attach an OBSN to is ~0.35" -- that allows about 3-4 threads to engage between the nut and button. Scott |
| Benzinbruder:
You could also first drill the 30 mm hole from the top and then expand it with a router in the bottom. _____ ______ _| |_ ___| |____ |
| keilmillerjr:
Route an area around your buttons on the back side. Done. Now use the buttons you like. :) |
| DeLuSioNal29:
No need for a router... Just use a bigger drill bit as noted above. Same effect. D |
| Ginsu Victim:
--- Quote from: DeLuSioNal29 on April 16, 2014, 12:40:52 pm ---No need for a router... Just use a bigger drill bit as noted above. Same effect. D --- End quote --- Yeah, I just use two different spade bits. |
| Navigation |
| Message Index |
| Next page |
| Previous page |