Multi Lightgun Game Arcade : USB2Gun with Recoil

Main > Project Announcements

<< < (15/19) > >>

Jollywest:

--- Quote from: Malenko on June 09, 2018, 11:54:41 am ---That is an immense help. Do you have a mala game list?

And did you set up any console lightgun games with any success? Like the super scope games or even the PS2 ports of the crisis games?

--- End quote ---

I've never tried any console emulators on it, only arcade emulators plus a couple of PC games.
I've attached my MALA Game list and a list of compatibility issues I came across in some games.

Easybeatuk:
I've been reading through the thread and may be of help with regards to front ends and consoles as I've been working on an Aimtrak modification project (which I'll post up at some point). I've managed to get the following emulators to launch using just the Aimtrak through a Simpletouch FE skin by a mixture of BAT files, Autohotkey scripts, command line etc. In game they all use the Escape key to exit and they then drop back into Simpletouch FE. The list below are all tested and it's only Mame games which consistently need anything other than the escape key.

4evervintage:
Hi, I have been reading this thread but being a newbie I have been struggling with being able to move forward on a project. I have acquired an america's army arcade game. There was no monitor or computer but everything else intact. I have picked a makvision 27/29" monitor and also have a computer with Windows 7 OS. I have downloaded and installed
groovymame. I have downloaded many of the games that Jollywest has on his game. At this point games start but none have any accuracy on the guns. Like Jollywest the USB2 reports as Lightgun 2.03. Each individual gun reports as gun 1. I have calibrated the guns in windows. My problem is where to go next. Any help would be appreciated.

BadMouth:
Each game has an original service menu where the guns also need to be calibrated. The default key in mame is F2, but some older (early 80's) games used dip switch settings. See if you can get it working in one of the newer ones first.

Jollywest:
Have you changed the mame.ini file, as explained in post 12;
‘However, they are working great in MAME. I had to change a few settings in mame.ini to get them to work though.
I had to enable joystick and off screen reload in device input, have joystick as the lightgun and positional controller and had to change joystick deadzone from 0.3 to 0.0 and joystick saturation from 0.85 to 0.95.’

Also, make sure mame isn’t changing the resolution of games to that of something different than your windows resolution. I use 640 x 480.

Navigation

 Message Index

Go to full version