Main > Main Forum
CP artwork is pinched up against the perspex
(1/2) > >>
Connorsdad:
The artwork on my CP seems to pinch up against the perpsex when I install the buttons and joysticks, it looks as though someone has spilled a drink over it :(

I don't know what's causing it, static maybe?
I have the same trouble with my G4D cab, the artwork for that one was printed on gloss paper, the artwork for my current build is printed onto vinyl.
Anyone else have this trouble?
Louis Tully:
.
eds1275:

--- Quote from: Connorsdad on February 22, 2014, 06:30:38 am ---The artwork on my CP seems to pinch up against the perpsex when I install the buttons and joysticks, it looks as though someone has spilled a drink over it :(

I don't know what's causing it, static maybe?
I have the same trouble with my G4D cab, the artwork for that one was printed on gloss paper, the artwork for my current build is printed onto vinyl.
Anyone else have this trouble?

--- End quote ---

Maybe wrap some teflon tape around the threads so that they won't loosen over time, and tighten them enough to not move but not enough to warp the art.
yotsuya:
Go to a craft store and buy a matte finish clear coat to spray on your graphics. That's what I've done and it works great.
Connorsdad:

--- Quote from: yotsuya on February 22, 2014, 10:57:51 am ---Go to a craft store and buy a matte finish clear coat to spray on your graphics. That's what I've done and it works great.

--- End quote ---

Fantastic tip Yotsuya  :applaud:, sprayed 2 coats and its a hundred times better than it was, almost pinch free apart from a few small specks that you cant see unless inspected closely. Thank you  :cheers:
Navigation
Message Index
Next page

Go to full version