| Main > Main Forum |
| UltraStik 360 - Why isn't output mode working? (re: IPAC) |
| (1/2) > >> |
| sofakng:
I've installed two UltraStik 360's into my cabinet and the USB-mode works fine and Windows detects the joysticks. However, I've attached the 10-pin header to the joystick, and then connected the following wires: USB = (connected to PC) BLACK = IPAC GND ORANGE = P2 - Right YELLOW = P2 - Left GREEN = P2 - Up RED = P2 - Down However, the IPAC doesn't detect any inputs from the joystick. Do I have to enable the "Output Mode" of the U360 joystick somehow? I am also wondering if I could daisy-chain the four direction wires to my dedicated 4-way joystick (so both joysticks could be used in digital/keyboard mode if I wanted) |
| mgb:
Do you have 5 volts wired to it. |
| sofakng:
I don't think it's needed because it's powered via USB, right? |
| mgb:
I may be wrong, as I've never used one but I believe you will need to wire up 5 volts to the output wiring harness. |
| EMDB:
Output mode is autodetected. You don't need 5V if connected to USB. I use my U360 this way without any problem. |
| Navigation |
| Message Index |
| Next page |