| Main > Main Forum |
| look what i got today!! |
| << < (5/10) > >> |
| Generic Eric:
--- Quote from: PL1 on February 03, 2014, 10:34:51 pm --- --- Quote from: mgb on February 03, 2014, 09:55:32 pm --- --- Quote from: Slippyblade on February 03, 2014, 08:48:57 pm --- --- Quote from: SpatzST on February 03, 2014, 08:12:07 pm ---What type of wire do I need to successfully daisy chain the ground connector? --- End quote --- I think it was Knievel that recommended the solid strand doorbell wire from Home Depot (or similar). --- End quote --- Prefab daisy chains FTW. Scott --- End quote --- Daisy Chain once, and you'll appreciate someone else doing it! --- End quote --- |
| PL1:
If you want to make the prefabs look neater (no left over QDs), use prefab daisy-chain (P) for all but the last connection (C) before a long run with nothing to ground. Encoder Ground | P---P---P---P---P P---P---P---P---P | | P---P---P---P---C--------------------C---P---P---P---P Player 1 (Joy + 6 buttons) Player 2 (Joy + 6 buttons) Highly recommended for cocktail setups. :cheers: Scott |
| SpatzST:
Thanks guys! Il check out that book too |
| yotsuya:
Buy a cheap JAMMA harness on eBay and use those wires. Much, much easier and cheap, too. |
| Unstupid:
--- Quote from: PL1 on February 04, 2014, 12:09:58 am ---If you want to make the prefabs look neater (no left over QDs), use prefab daisy-chain (P) for all but the last connection (C) before a long run with nothing to ground. Encoder Ground | P---P---P---P---P P---P---P---P---P | | P---P---P---P---C--------------------C---P---P---P---P Player 1 (Joy + 6 buttons) Player 2 (Joy + 6 buttons) Highly recommended for cocktail setups. :cheers: Scott --- End quote --- I'd go like this: Encoder Ground | | P---P---P---P---P P---P---P---P---P | | P---P---P---P---C---------------C---P---P---P---P |
| Navigation |
| Message Index |
| Next page |
| Previous page |