Main > Main Forum
what the hell do I do with this (rude answers on a postcard)
Brian74:
:dunno
stigzler:
God, this is frustrating. Can't find any manual anywhere - so have no idea how to wire this enigmatic lump of ****. The 12V, Grnd and P1 pulse seem straightforward - but no idea how to wire from coin mech to credit board. Reading a namoi manual - see you wire to validator A pins, but can't find a pin schematic anywhere :(
Rubbish.
Generic Eric:
--- Quote from: stigzler on February 01, 2014, 04:02:10 am ---God, this is frustrating. Can't find any manual anywhere - so have no idea how to wire this enigmatic lump of ****. The 12V, Grnd and P1 pulse seem straightforward - but no idea how to wire from coin mech to credit board. Reading a namoi manual - see you wire to validator A pins, but can't find a pin schematic anywhere :(
Rubbish.
--- End quote ---
If it wasn't for all of those trekies, I feel the search would be easier to search for. Most mentions refer to a later model of pcb. Do you know what game that was originally used in? have you looked at http://www.arcade-museum.com/manuals/ or that websites forum?
eds1275:
If you are just trying to wire from the coin mech to the credit board, can't you just use a multimeter and poke around until you register some creds?
Franco B:
There's an IDC type connector that goes from the C120 mech to the credit board. There is then a 0.156" KK Molex connector on the credit board that handles power and the coin output signal etc, I'll get you the pinout for that tomorrow once I inspect a cab.