| Main > Main Forum |
| what the hell do I do with this (rude answers on a postcard) |
| << < (3/4) > >> |
| Brian74:
:dunno |
| stigzler:
God, this is frustrating. Can't find any manual anywhere - so have no idea how to wire this enigmatic lump of ****. The 12V, Grnd and P1 pulse seem straightforward - but no idea how to wire from coin mech to credit board. Reading a namoi manual - see you wire to validator A pins, but can't find a pin schematic anywhere :( Rubbish. |
| Generic Eric:
--- Quote from: stigzler on February 01, 2014, 04:02:10 am ---God, this is frustrating. Can't find any manual anywhere - so have no idea how to wire this enigmatic lump of ****. The 12V, Grnd and P1 pulse seem straightforward - but no idea how to wire from coin mech to credit board. Reading a namoi manual - see you wire to validator A pins, but can't find a pin schematic anywhere :( Rubbish. --- End quote --- If it wasn't for all of those trekies, I feel the search would be easier to search for. Most mentions refer to a later model of pcb. Do you know what game that was originally used in? have you looked at http://www.arcade-museum.com/manuals/ or that websites forum? |
| eds1275:
If you are just trying to wire from the coin mech to the credit board, can't you just use a multimeter and poke around until you register some creds? |
| Franco B:
There's an IDC type connector that goes from the C120 mech to the credit board. There is then a 0.156" KK Molex connector on the credit board that handles power and the coin output signal etc, I'll get you the pinout for that tomorrow once I inspect a cab. |
| Navigation |
| Message Index |
| Next page |
| Previous page |