Arcade Collecting > Merit/JVL Touchscreen

Megatouch XL - motherboard ??

<< < (7/12) > >>

ed12:
cush
here is what i was refering to
>Also located within the cavity of the coin mech are 2
internal switches, ”SETUP” and “CALIBRATE,” and
the coin meter. Location of these switches can be
seen in Figures 5 and 7. Pressing the “SETUP”
button will bring you to the Megatouch Setup screen
(see Figure 1). See the next section for calibration
instructions. The remote monitor controls are also
located inside the coin mech section, Velcroed to the
top of the coin box.<
they must be there and active
if like u said the wires are messed up
i have the ppw on them.

ed

cush:
ed from what I can make out the two buttons "setup" and "calibrate" have wires attached then the loom goes to a black box which I think is the credit control box and 2 plugs from that are unused which must have gone to the coin hardware on the door which has been removed.
The narrow ribbon cable from the 2 buttons also  connects to the I/o board.

ed12:
if u look at the cash box with the accepter in place
u either have a plug with alot of green wires on it ?
it not it is a thin ribbon cable style plug..
now if it is the 1 i know for them,it will have 6 green wires,1 white wire,1 yellow wire.
this is from the accepter,the 2 buttons will have 3 wires in total,then u will
have a black and a white :high power: wires,these were to go to 117vac or in your case 220vac,we make no never mind of them 2..
now all of the green wires/yellow wirw/white wire/and the 3 from the switchs must be tied into the i/o card through a couple of headers,1 that the coin asambley plugs into,and 1 that plugs into the i/o board
lets this out of the first..
if u need i will see if i can up-load a pic.

ed

cush:
ed I pm you some pics of the wires and bits on coin door.

ed12:
i did..
and as i said in the return pm,i have never seen a cash code in a merit ?
maybe another >@< can chime in on this ?

from there i d/l the link,i will look in my cash code book of things..
also that dose answer the question about :some of the dip switchs:.

ed

Navigation

[0] Message Index

[#] Next page

[*] Previous page