Arcade Collecting > Merit/JVL Touchscreen

Megatouch XL - motherboard ??

<< < (3/12) > >>

ed12:
ok
i took the time to dump them
u11
and
u12
ran both through a crc chker to make sure they were right
bing bang boom they are.:):):)
if u want i can dump the dallas bat chip? why  :dunno
as it is olny a time keeper,back-up high score,game >date-keeper< !thk's SHAWN:)!
but in any account,they are saved as .bin's
if needed i can convert to hex using bin2hex >thk's alo166< for the fine conveter

ed

cush:
Ok I took out micro and re did compound ect and new cmos battery but still getting disc failure  :'(

ed12:
read your pm
if u want copy and paste it to the thread.
we need this test done as i explained to you

ed

lilshawn:
step through the boot and check and see if the drive is being detected by the computer itself. perhaps it's gone south on you.

one of the first few screens you see when you boot it on (just after the memory test) should have the drives detected shown.

cush:
I took out the riser and I/O card and attached an old hard drive, the unit auto detected it fine.
It started to boot the drive and got to a white progress bar at the bottom of screen and then just keeps rebooting and is stuck in that cycle, this is probably the drive itself as it is an old 4.3gb that I found in a junk box as Im not sure the old 486 mobo would see a large modern drive.

Navigation

[0] Message Index

[#] Next page

[*] Previous page