Main > Main Forum
Yet another grounding question
marvin_rock:
So I'm re-doing all my cabling. I didn't like the messiness with the cables that came with my buttons, I'm a bit OCD like that.
Here's what I have for my regular switches -
Mostly pay attention to the yellow/blue buttons setup.
As far as the grounding goes, can I do something similar and just have a single ground cable come from one side of the board, and a single ground come from the other side, join them up and put them into the single ground connector? Or do I have to have one single cable hop between 32 different ground connections?
I can attempt to explain better if needed.
Louis Tully:
.
marvin_rock:
Close - but here's a shoddy diagram of what I'm HOPING I can do, the image you posted shows them 100% daisy chained, which I'd like to avoid if possible. Here's what I'd like to do (attached)
Louis Tully:
.
Dawgz Rule:
Easy to remember saying...."Ground is ground all around"
As long as they are all tied together in some form, you are good to go.