Main > Driving & Racing Cabinets
Logitech G27 Question
slamminsam:
--- Quote from: BadMouth on December 12, 2013, 01:54:19 pm ---Looks like you've got a lot going on there that I've always wanted to try. ;D
Hollow shaft with the spinny-wire thing....
--- End quote ---
BadMouth, I remember seeing a post where you touched on the subject, but I can't seem to find it. Do you happen to know which post it was? TIA
NM I found it: http://forum.arcadecontrols.com/index.php/topic,105003.msg1220482.html#msg1220482 :)
slamminsam:
After doing some testing, 19V is the lowest voltage that allows the G27 to go through the calibration process. Its not the 15v that I was hoping for, but it will not put as much stress on the servo amp that the 24v will.
Navigation
[0] Message Index
[*] Previous page
Go to full version