| Main > Lightguns |
| 2 AimTrak Light Gun setup |
| << < (2/8) > >> |
| jackiabu:
--- Quote from: BadMouth on December 09, 2013, 04:00:20 pm ---My guess is that you left both guns as Device ID 1. You need to change gun #2 to a different ID before plugging them both in. --- Quote ---Basic Tasks: Assigning ID.If you are connecting more than one gun to a PC, each one must have a unique ID.The ID is assigned by clicking on the "Assign ID" tab. --- End quote --- from this page: http://www.ultimarc.com/aimtrak.html Step by step instructions: http://www.ultimarc.com/AimTrak%20Setup%20Guide.pdf --- End quote --- Thanks men... but I've been see these links before. And try to change the ID .problem now is giving me all the time the message "Unhandled exception has occured in your application" any other idea please? |
| BadMouth:
--- Quote from: jackiabu on December 09, 2013, 04:09:42 pm ---any other idea please? --- End quote --- That was my only idea. :dunno |
| jackiabu:
can somone tell me please how to config and Calibrat whit this util Aim-Trak my gun. it was OK until i connect the second gun! and install the Aim-Trak util. the calibration is not Accuracy no matter how i try. |
| spratkobasa:
Make sure your sensor bar is in a good position and that your light gun can see the bar no matter where you point on the screen. Also the Aim trak has software to calibrate the guns even further which can help. I found holding the trigger down for 30 seconds restarts the calibration so you can adjust on the fly for games that are 4:3 vs games that are in 16:9. Hopefully this helps. Also make sure your Joystick ID's are setup correctly using the aimtrak software that ultimarc gives you on their site. |
| jackiabu:
--- Quote from: spratkobasa on December 13, 2013, 11:48:50 am ---Make sure your sensor bar is in a good position and that your light gun can see the bar no matter where you point on the screen. Also the Aim trak has software to calibrate the guns even further which can help. I found holding the trigger down for 30 seconds restarts the calibration so you can adjust on the fly for games that are 4:3 vs games that are in 16:9. Hopefully this helps. Also make sure your Joystick ID's are setup correctly using the aimtrak software that ultimarc gives you on their site. --- End quote --- my sensor bar is in a good position. I have to say this program is a shity one :angry: i try to calibrate but again no luck the gun just out of range...the ID is ok. by the way where should i calibrate the gun? in Configuration? Sensor View Check? Displaying Calibration Errors? or the SHOW DATA Tab? Although I tried all of them in all sorts of variations :dizzy: With all the respect to the http://www.ultimarc.com/aimtrak.html site itself has an explanation for all TAB. but why not be explained step by step from start to finish? |
| Navigation |
| Message Index |
| Next page |
| Previous page |