| Main > Main Forum |
| Pressure Waves in my control panel art |
| << < (3/3) |
| PL1:
Trim the art so it is just slightly (~1/32" - 1/16") smaller than the panel/plexi. Sharpie/black paint around the panel top/edge so that the part not covered by the art blends with the t-molding. Scott |
| jdbailey1206:
--- Quote from: spratkobasa on November 22, 2013, 10:19:46 am ---I didn't want to have a vinyl or glue so that if anything happened I could removed the artwork to do repair on joysticks etc. If I glue it I wouldn't be able to get my joysticks out of my control panel as it is top mounted. --- End quote --- Completely understandable. Most joysticks can be removed from their housing without removing them from the control panel. |
| spratkobasa:
Thanks everyone for your help. I took my scalpel and did several more passes to get rid of any excess paper going over the edge. I double clamped the area I was hammering in. Then declamped and reclamped all the way as I progressed along the edge of the control panel. Zero pressure waves :). |
| Navigation |
| Message Index |
| Previous page |