| Main > Main Forum |
| Pressure Waves in my control panel art |
| (1/3) > >> |
| spratkobasa:
Hi Everyone, I had everything cut perfectly for my control panel I attached the artwork (its a piece of paper not sticker) and put the plexi on and screwed all the buttons to hold everything together. So then I start to hammer in my t-molding to finish the job and I see pressure waves forming in my control panel side art! :angry: :banghead: I immediately took out the tmolding which removed alot of the pressure wave warping. Where did I go wrong? Also what should I do. This is my first control panel ever and I put so much time into it I don't want it to be messed up. Right now I am considering removing all 48 buttons and taking the artwork out and hammer in the t-molding with out the glass and then adding it back in. What should I do? |
| lilshawn:
take pictures of it so we know what you are talking about....cause i ain't got nothin' |
| spratkobasa:
See attached some of the waves. It's really hard to get a picture of it in real life is is very apparent. You only see a little in this picture as I bummed a little t-molding to demonstrate. Basically the paper doesn't stay flat it becomes wavy from me hitting the t-molding with a hammer. If you need more pictures let me know. |
| matt4949:
|
| spratkobasa:
So it wasn't just me then. What did you guys do to fix it? I am flirting with the idea of putting on the t-molding first before the glass and paper artwork. |
| Navigation |
| Message Index |
| Next page |