Main > Main Forum
CPS2 RCA to 1/8th Computer Speakers
(1/1)
ParryPerson:
I'm using the red/white outputs from the CPS2 A board to a pair of powered monitors that have red/white inputs. These are expensive studio monitors I'd like to have back. I found some old PC powered speakers (for a computer) and was wondering if I could use those?
I just bought a cable from Target that has male red/white to female 1/8th.
However, it only talks about sending the audio signal from the 1/8th to the RCA red/white, and not the other way around. I'd like to know before I slice into the package if this might work?

The reason I can't use the JAMMA audio is below, which is still an aggravating problem.

I have a really odd problem with my CPS2 JAMMA mono sound output. It will only play sound to the speakers if I connect the wires while the cabinet is on. If I turn it off, then back on again with the wires connected from the start, I get no audio from the speakers. Disconnect them in the middle, then touch them back together, and bam, audio.
Still haven't figured that one out.
Navigation
Message Index

Go to full version