Main > Main Forum

Cleaning dirty wires.

Pages: << < (2/4) > >>

thehammer12:

Ill try the electrical cleaner first haha, if not.....lighter fluid lol.

TKW4rr10r:

Simple Green does wonders with the decades old crud. Cuts right through it.
As long as you rinse it clean and dry it with compressed air and/or let it sit out, you should be fine. Emphasis on giving it loads of time to fully dry.

matt4949:


--- Quote from: pbj on November 04, 2013, 12:38:38 pm ---I use lighter fluid and a brush personally.  Soap and water wouldn't hurt a thing in this situation.

Transformers rarely go bad.  Just wire it up and check the lugs with a digital multi-meter for proper output voltages.



--- End quote ---
Same here but 91% ISO Alcohol. I keep a big squeeze bottle of it next to my solder station. Use it to clean flux. After tooth brush and alcohol I spay with compressed air.


pbj:

We used 189 proof rum in the Caribbean.  Cheaper than anything else.   ;D



jennifer:

   I use A 3 stage process... First hot water with a few drops of Ivory dish soap, (That gets most of the crud), Then a simple green bath, (thats for the buildups), Then on problem areas, a quick wipe/dry with Butyl acetate. (A fairly harsh thinner ) .... Then dry under heat lamp, (or bake in oven) to displace moisture.

Pages: << < (2/4) > >>

Go to full version