| Main > Main Forum |
| Mounting LCD/Screen |
| << < (3/4) > >> |
| dfmaverick:
Yep. Just like Knievel did on the Woody. You can see the four screw holes in the board. (Reply #70) http://forum.arcadecontrols.com/index.php/topic,55789.msg550105.html#msg550105 |
| ChanceKJ:
. |
| sleong:
--- Quote from: ChanceKJ on October 24, 2013, 12:10:39 am ---I'm currently building my Cab to use a 32" LCD and I've gone with a very basic wall mount. I picked up a "Xtreme Ultra-Slim" wall bracket at Princess Auto for like $13. They were $40-$70 everywhere else. i just needed a slim, basic rail VESA mount. I figure i could mount it right to the wood, but i'm a bit of a perfectionist, and i want to make sure it mounts square, and is easy to remove if need be. I felt that mounting to the wood i could possibly have issues with it being level when i go to put the bezel and plexi overtop. ...I don't know, i over engineer stuff sometimes. --- End quote --- Thank you for all the suggestions and help! I think I'll just get 4 longer M4 screws to mount the LCD. I was thinking of what ChanceKJ was going to do so that if I did mount it off center I could still center it easily by just moving it slightly. But since this is a small bartop I'll just measure a few times then drill and mount to the board. Worst case is if I mess it up I'll just cut another board and re-drill the holes. After mounting then I need to make a bezel. I'm not sure if I'm doing this in the right order but I thought I'd mount the screen then build the bezel around it to get a better fit! :cheers: |
| ChanceKJ:
. |
| Monkeyvoodoo:
--- Quote from: ChanceKJ on October 24, 2013, 12:33:21 pm ---Makes sence to me. It's not like we're building naval warships. Just build and measure and build as you go. :) --- End quote --- You should see how our warships are built. Not as well designed as you would expect. ;) |
| Navigation |
| Message Index |
| Next page |
| Previous page |