Main > Main Forum
Best way to attach control panel to cabinet?
<< < (3/3)
BobA:
Just go slow and steady.  The UAII control panel instructions show the pieces needed to box in the panel.
Tzakiel:

--- Quote from: BobA on October 21, 2013, 11:11:10 am ---Just go slow and steady.  The UAII control panel instructions show the pieces needed to box in the panel.

--- End quote ---

Edit: Aha! found it under kits rather than controllers. That is some help, along with dimensions of the controller product. I guess that gives me a start.  Thanks!

Hi Bob, where is that document located?  I took measurements from my cab but I'm having a hard time picturing all the pieces and angles I will need to cut. I don't see that doc on their site however.
BobA:
Forgot if you are doing a 2p or a 4p but the 4p is the size that the UAII uses.  The 2p would probably have to be altered to fit the base on the UAII.  I have attached both documents which were available on their site when I downloaded them.

Tzakiel:
Thanks Bob.  I am making a photoshop file with pieces and dimensions drawn out. Once I am confident it's right I might send it your way to see if you agree. Based on the 2p classic controller and actual dimensions of my cabinet's shelf.
Navigation
Message Index
Previous page

Go to full version