Main > Main Forum

T-Molding for quarter inch wood

Pages: (1/3) > >>

cigardude:

Hi everyone. I've been searching for some 1/4" t-molding but no luck. Has anyone ever used it before? Do you have any other suggestions to finish the edges?

PL1:

How about something like GRE34078A.




Scott

eds1275:

I would just get some regular and follow any one of the methods opn this site for trimming. The sharp chisel seems to be the most popular, but I have had luck with a veneer trimmer tool that only does one side at a time that is available at home depot for $7.

jdbailey1206:

My understanding is that they only sell .5" to 1.5" sizes.  I've never heard of anything as small as 1/4".  If its possible I would get 1/2" material for your build.  If you have already built your machine I would have to agree with eds.  But keep in mind if you go with a trimmer you won't have a smooth rounded edge.  It will be noticeable when you trim it. 

Nephasth:

Use a round over bit with your router.

Pages: (1/3) > >>

Go to full version