| Main > Main Forum |
| PC through CAPCOM I/O |
| (1/1) |
| bimm25e:
So I have successfully outputted the video signal from my computer through my CAPCOM I/O to the cabinet monitor from a DYNAMO HS5 My plan is to buy a KVM switch to allow me to jump between the computer and the NAOMI with the press of a concealed button. Anyone know of a good way to use the same buttons for the NAOMI and the PC once I swap? Does a CAPCOM I/O sync with a pc? Could I maybe even do it through the KVM? Could I just hop on the same switches with my existing USB controller? I found the website for the jvspac but I don't see where on that page to buy them. Is there really not a driver for windows 7 for a Capcom I/O? |
| MonMotha:
The Capcom IO board isn't actually USB. It's JVS. About the only thing the two standards have in common is the connector (JVS deliberately used the USB connectors/cables because they were "readily available"). There are some people who make JVS PC interfaces. They'll give you real USB or maybe PS/2 which you could then use via a KVM, if you want to. Unfortunately, every JVS IO board (especially from different vendors) has a different register map, so you need to make sure you find one that supports the board you have. The Capcom one is one of the most commonly supported, at least. |
| bimm25e:
is it a bad idea to use the same micro switches to run 2 controller boards? Is it something that's do-able with diodes? say a jvs>usb and a Capcom I/o sharing switches. I could easily solder a USB joypad controller card to the buttons, just hop on the switches but is it a bad idea to do this? |
| bimm25e:
so I built a switch for the control panel that has 32 poles! I got all the buttons switching perfectly but now I need to get the PC on the screen. What resolution should I be aiming for? |
| Navigation |
| Message Index |