Main > Main Forum
Controller panel parts list... do I have it right?
<< < (3/3)
PL1:

--- Quote from: Tzakiel on September 30, 2013, 11:56:30 am ---Can you give me some idea of which specific products to look into from Paradise? Looks great but the selection is a bit overwhelming. The rainbow packs? What size would make sense for the connectors, given I am using sanwa parts (but maybe happ for 1p, 2p, exit, pause)

--- End quote ---

Sanwa buttons use 0.110" tabs and the Happs use 0.187". (Check the description and ask the vendor if you're not sure.)

Use the Rainbow pack wires to connect the buttons to the encoder inputs and daisy chains to connect the other side of the button/microswitch to ground.

Any wires you don't use on this build, you can use on the next one.   ;D


Scott
yotsuya:
I buy $14 speakers and tear them apart, using the powerboard/amp and connections and solder wires to the cabinet speakers. I then mount the amp PCB near the coin door to adjust the volume if need be.  :cheers:
CoryBee:

--- Quote from: Richardgregory on September 30, 2013, 02:38:02 pm ---Volume up and down - hmm, never thought of that, but these days you can get PC speakers that have a remote control were volume can be adjusted - challenge here is I think it's Infrared.

--- End quote ---

Infrared will pierce right through your marquee art so that makes a good place to hide it behind.


--- Quote from: paigeoliver on September 30, 2013, 03:30:00 pm ---You can also just unsolder the speakers volume knob and run it someplace accessible.

--- End quote ---

I do this on all of my full size builds. Have a ton of Cat5 cable so just use that as the wire.
Navigation
Message Index
Previous page

Go to full version