| Main > Main Forum |
| Spinner |
| << < (2/2) |
| yotsuya:
--- Quote from: Richardgregory on September 30, 2013, 12:24:47 pm ---Thanks for all the information on the knobs - question though: if I order the TT2, they automatically give you the stock knob and they don't replace it if I order a different knob do they? --- End quote --- I upgraded the knob on mine when I ordered and only received that one. The stock knob was not included. |
| Richardgregory:
Thanks - oh.....so they take the stock knob out. Hmm.....was hoping they'd leave it in - never hurts to have a spare and besides one my prefer the lower stock version over the other. |
| PL1:
The only reason I have both is that Randy allowed me to buy the rubber knob and steering wheel as part of a later order. :cheers: Scott |
| GeoMan:
--- Quote from: Richardgregory on September 30, 2013, 12:24:47 pm ---Ooops, my mistake - I didn't see that picture of the Ultimarc with the PCB interface attached - hmm, it is smaller than the TT2's too, so that's kind of nice. --- End quote --- You don't need the PCB interface if you use a MiniPac to drive your control panel. You can connect the spinner directly to it. Here's the diagram: http://ultimarc.com/mp_inst.html |
| Navigation |
| Message Index |
| Previous page |