Main > Main Forum
Mag Stik Plus - hole size
Richardgregory:
I understand that the Mag Stik comes apart in a way that the shaft and mounting plate can be all dislodged. In that regard I'm thinking whether I should just do that instead of making a hole and feeding the bat stick through. I will drill a smaller hole such as 1 1/8 and feed the shaft through and then reassemble the unit. That way, if I ever change joysticks, I'm not left with a larger hole from the Magstik.
I believe the hole size that I need to fit the Mag Stik through is 1 3/8"??
BobA:
Mag Stik comes apart easily and uses a 1 1/8 hole in my cabs.
Richardgregory:
Hmm...a hole size of 1 1/8" will allow the bat top the feed right through? The bat top seems larger than that. The specs says 33mm, which I thought would require a 1 3/8" hole
EMDB:
--- Quote from: Richardgregory on September 11, 2013, 12:33:30 pm ---Hmm...a hole size of 1 1/8" will allow the bat top the feed right through? The bat top seems larger than that. The specs says 33mm, which I thought would require a 1 3/8" hole
--- End quote ---
Just drill a 1 1/8"hole like for the buttons. Place the shaft after under-mounting the stick:
Dawgz Rule:
Exactly how I did it as well.