| Main > Main Forum |
| Rewiring control panel soon...Quick question about wire... |
| (1/3) > >> |
| redbeard30:
I'm in the process of redoing my cp wiring and was going to buy some bulk 22awg wire, it is "tinned" copper strand. I don't recall any one mentioning not to use tinned wire. Will this be OK to use? The only Con's I saw was possibly lower conductivity(use for cp controls I can't imagine one would notice), and its a little stiffer than non tinned. Any advice? |
| PL1:
Should be fine if it is stranded instead of solid core. Just to be sure, can you post a link? Scott |
| CoryBee:
--- Quote from: PL1 on September 06, 2013, 09:43:55 pm ---Should be fine if it is stranded instead of solid core. Just to be sure, can you post a link? Scott --- End quote --- Sounds like it is going to be solid core if it is tinned |
| JDFan:
--- Quote from: CoryBee on September 06, 2013, 10:01:01 pm ---Sounds like it is going to be solid core if it is tinned --- End quote --- They do have tinned stranded wire also : |
| CoryBee:
Didn't say they didn't. Just less common in online and walk in retail shops. OP don't leave us hanging! |
| Navigation |
| Message Index |
| Next page |