| Main > Main Forum |
| Question Regarding Getting trackball to work |
| << < (3/5) > >> |
| Yourname942:
I'm a little confused about the wiring you are suggesting. |
| Yourname942:
here are a few more pictures for a clearer image of my current wiring: here are the wires from the NorthEast side of the trackball: and here is the thicker ground wire I think: Is this correct? |
| PL1:
1. Move the red wire 4 places to the right. 2. Disconnect the yellow and two green wires. 3. Boot system up to see if the X-axis is working. 4. If x-axis isn't working, change the P1 Trackball setting in the software. Once you get X-axis working, we'll work on Y-axis. Scott |
| PL1:
--- Quote from: Yourname942 on August 24, 2013, 02:48:44 pm ---and here is the thicker ground wire I think: Is this correct? --- End quote --- The Green wire in the upper right isn't attached to the opto boards (red board lower left), so it appears to be the "Frame Ground" that I referenced earlier for dissipating static charges. Scott |
| Yourname942:
I moved the red to the x axis +5 and took out the greens + yellow, opened the optipac software utility but it still doesn't do anything. Edit: here are the wires from the NorthEast side of the trackball: and here are the wires from the SouthWest side of the trackball: |
| Navigation |
| Message Index |
| Next page |
| Previous page |