Arcade Collecting > Pinball

Roadshow switch issue - Resolved

<< < (4/4)

smartbomb2084:
I have been here several times before with U20.

So far so good... We still haven't officially determined the cause of U20's failure...

Hopefully, before you got the game,  some TOOL was adjusting things with the power on and caused some kind of temporary short...blowing U20.

Since you did not find anything wrong with the Column switches themselves ...we may be good...

If U20 dies again after an extended time of play then CPU U23 is bad too...

U23 is hard to check accurately without removing it from the board....

I am keeping my fingers crossed and praying to the Pinball Gods for you...Good Luck.

 :cheers:

spoot:
Woot!  Time to wreck some roads!

Navigation

[0] Message Index

[*] Previous page