| Main > Main Forum |
| Securing PCI / Graphics in De-cased PC |
| << < (4/6) > >> |
| charlieram:
You could just do what i did and get some of the brass standoffs and screw/glue them into your cab for the motherboard and a good old bit of meccano to secure the top of the Gfx card |
| Minwah:
--- Quote from: Nephasth on July 31, 2013, 02:49:14 pm ---I cut stainless screws/bolts all the time. Thread a nut on past the point you want to make your cut. Cut do desired length (I use a cutoff wheel, but a hack saw works too). --- End quote --- Ok thanks, I thought a saw (I only have a junior hacksaw) would have a hard time cutting stainless steel - I will give it a try. |
| TopJimmyCooks:
i've seen hot glue used as well- right at the corner of the board and the socket. |
| UFO:
I love all these ideas, and the creative thought process that went into them! Plenty to think about here - cheers guys... :cheers: |
| rockyrocket:
--- Quote from: TopJimmyCooks on August 01, 2013, 09:19:50 am ---i've seen hot glue used as well- right at the corner of the board and the socket. --- End quote --- +1 Hot glue works wonders. |
| Navigation |
| Message Index |
| Next page |
| Previous page |