Main > Main Forum

Anybody with a Midway cabinet that can help?

Pages: (1/3) > >>

agent4877:

Hi everybody


I'm almost certain my cabinet is missing a piece. A piece that hold the monitor glass at the bottom. Take a look at the pictures. The cabinet is a killer instinct

Can anybody with a similar cabinet comment and post pictures for me to see what I'm missing?

Thanks!

Malenko:

you are not missing a piece there, the part that holds the glass in at the bottom is part of the control panel. Pretty sure you asked about this before, answer is the same. I can take pix of both my KI and my MKII when I get home if the picture below doesnt suffice:


http://i890.photobucket.com/albums/ac101/psoostkamp/arcadepics/KI1/KI1_origional/KI1_rightnoflash.jpg

agent4877:


--- Quote from: Malenko on July 19, 2013, 08:25:52 am ---you are not missing a piece there, the part that holds the glass in at the bottom is part of the control panel. Pretty sure you asked about this before, answer is the same. I can take pix of both my KI and my MKII when I get home if the picture below doesnt suffice:

--- End quote ---

Thanks for the reply ... Yes I was concerebed about how to secure the glass before, but i realized i difnt know how it should sit. So the glass should sit on the metal strip that is attaced to the control panel? Hence you cannot open control panel unless you take glass out?

Any other close up pictures would be appreciated!

Thanks!

Malenko:


--- Quote from: agent4877 on July 19, 2013, 08:47:48 am ---Thanks for the reply ... Yes I was concerebed about how to secure the glass before, but i realized i difnt know how it should sit. So the glass should sit on the metal strip that is attaced to the control panel? Hence you cannot open control panel unless you take glass out?

Any other close up pictures would be appreciated!

Thanks!

--- End quote ---
No, the other way. The glass sits on the wood, then the control panel closes holding the glass in place.

agent4877:


--- Quote from: Malenko on July 19, 2013, 09:03:20 am ---
--- Quote from: agent4877 on July 19, 2013, 08:47:48 am ---Thanks for the reply ... Yes I was concerebed about how to secure the glass before, but i realized i difnt know how it should sit. So the glass should sit on the metal strip that is attaced to the control panel? Hence you cannot open control panel unless you take glass out?

Any other close up pictures would be appreciated!

Thanks!

--- End quote ---
No, the other way. The glass sits on the wood, then the control panel closes holding the glass in place.

--- End quote ---

Would you be able to show me a picture of that piece of wood it sits on? I think I'm missing it.

Thank you!

Pages: (1/3) > >>

Go to full version