Arcade Collecting > Pinball
STERN STARS
TopJimmyCooks:
MMMMMM. conductor and insulator crimped at one time. very tasty.
I don't like how wide you have to open the handles on those ratcheting ones though.
smartbomb2084:
I need to make a clarification here....My math is fuzzy and suspect...
Upon looking at my notes for this game I realize that...
300 crimps is WITH the display contacts included...Which have NOT been done.
It is a little over 200 crimps WITHOUT the display contacts for the rest of the board interconnects.
I apologize whole heartedly for this error..I will try to make sure this kind of thing doesn't happen again.
smartbomb2084:
If you are going to shine up the boards and kill the corrosion, you need to remove it from the board mounting brackets too...
Here is a pic showing one that is cleaned and one that is not...
Ken Layton:
I use C-L-R and a brass bristled detail brush to clean the mounting bracket. Not only does it make the bracket look nice, but it also provides a good ground connection to the boards.
smartbomb2084:
I'll have to try CLR on the last one left. I have been using fine steel wool and a lot of elbow grease.
Maybe your way is less work with the same result.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version