| Main > Main Forum |
| Did I screw it up already? |
| << < (3/3) |
| BobA:
If you have enough room on the bit of pad a small drill bit in a dremel works well to add strain relief. |
| lilshawn:
i'd be cautious with a board that has tracks on both sides. Single sided would be fine to drill through. double sided, not so much. |
| BobA:
Lots of cheap game controllers are single sided to make them cheaply. Contacts and chip in blob on same side. Just flip over your board to check. |
| Navigation |
| Message Index |
| Previous page |