Arcade Collecting > Pinball
Damn GI....
smartbomb2084:
I measured resistance across transformer lugs 17 and 18 on two different Bally transformers and got .3 Ohms on one and .4 Ohms on the other....
Did you perhaps short GI Voltage to +43V Coil Voltage?
Toadie:
Good question but no, it's a regular bumper not a thumper bumper. Also the short occured from the top and not underneath. There would technically be no way for me to trigger the 43 coil :dunno
That I can think of that is. Later tonight though I'll go check the wiring and see what I have going on. Cross short is a concept I didn't think of
Toadie:
nah I was right just two wires, one red, one white. The same wires that tie all the GI's together when I follow the chain.
ChadTower:
Are you following the chain with your eyes or a DMM?
Toadie:
Just with my eyes. Right now I have no power. The rectifier board has been sent back for testing. In terms of the short I took out that screw and moved that light piece back to where it should have been.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version