Software Support > Automated Projects

Using parallel port and mamehooker for gun recoils

<< < (8/8)

DaOld Man:
Im not sure about the capacitance on the mosfets, I mean, all circuits have capacitance, even wires ran side by side will have capacitance, but it's usually not enough to even consider. (Unless you are building high frequency radio circuits.)
I will have to read up on the data sheets for that mosfet, but just a hint, most data sheets will give you a lot more info than you actually need. It can get pretty confusing if you let it.
If your circuit is working (and it appears to be), and you are not seeing any weird things going on, then I would say you are ok on your circuit design.
Is there something specific that is troubling you?

charlieram:

--- Quote from: DaOld Man on September 02, 2013, 11:56:02 pm ---Is there something specific that is troubling you?

--- End quote ---
I was just wondering if the changes would reduce the time that power was applied to the solenoid to reduce the heat up, I was looking at the specs for the mosfet which stated a Vgs of 10v (max of 30) and so I was trying to get just 10v to the gate and not 24v.
 I'm not overly concerned just striving for perfection. ;D

DaOld Man:
Well, try to adjust the resistors to give you 10 volts, cant hurt and may actually do what you want.

Navigation

[0] Message Index

[*] Previous page