Main > Main Forum
Free "CoryBee" Serial Plate
CoryBee:
--- Quote from: DaOld Man on May 25, 2013, 08:30:21 am ---Oh no, Im late.. oh well better late than never. Let's see now... ummm...here goes, is it 21?
--- End quote ---
BLACKJACK!!!!
JDFan:
--- Quote from: CoryBee on May 25, 2013, 03:16:30 am ---
--- Quote from: JDFan on May 24, 2013, 11:14:36 pm ---7
--- End quote ---
WINNER WINNER CHICKEN DINNER!!!!! :applaud: :applaud: :applaud: :applaud: :applaud: :applaud: :applaud: :applaud: :applaud:
LUCKY CONTESTANT "JDFAN".......COOOOOOOME ON DOWN!!!
Please submit your design to my PM box post haste and I will get in the order with the rest of the serial plates. Anyone else that would like to place an order please do now so I don't have to turn anyone down because of my busy schedule.
Hope you all had fun for the excitement of wining one of my custom serial plates!!!!!
:cheers:
--- End quote ---
COOL !!! Will be E-mailing the info in a few minutes (almost forgot to check in on this since I never win these things ) Perfect timing as I am just finishing up the build and this will look great on it !
Build this will be placed on :
Here's a .jpg of the label in case the E-mail doesn't arrive but will be sending the e-mail with a psd copy and jpg as well and mailing info in just a few minutes.
Buick455:
HA! It was a prime, I knew it :P Yay for JDFAN :applaud:
CoryBee:
JDFAN, serial plate design added to the cue. :cheers:
I will try to give out 1 - 2 every time I do a run of serial plates to give a little bit back to the community. Little things.
Cheers!
JDFan:
--- Quote from: CoryBee on May 26, 2013, 03:21:04 am ---JDFAN, serial plate design added to the cue. :cheers:
I will try to give out 1 - 2 every time I do a run of serial plates to give a little bit back to the community. Little things.
Cheers!
--- End quote ---
Arrived in the mail today and looks GREAT ! will definitely be placing it on the system just have to figure out where so that it can be seen -- Thanks again for running the Giveaway. The plating you are using is just the right thickness for these and even knowing they are actually a sticker placed on the plate it is hard to tell as they look more like they are printed directly onto the aluminum. Just the right finishing touch to add to a build. :applaud:
Here's a pic of where it willprobably wind up -
Or Maybe Here - ( Might place it on the side of the system where the USB ports will be as shown sketched on the side in the pic below )