| Main > Main Forum |
| Help with 360 wheel encoder to UHID |
| << < (4/5) > >> |
| MartinJames:
Its not I've configured 2 other pins from the J4 block. one for gnd and one for 5v as per picture. And to think I thought this was goign to be the easy part! |
| MartinJames:
--- Quote from: PL1 on April 24, 2013, 02:29:54 pm --- --- Quote from: vtivti on April 24, 2013, 02:08:48 pm ---Bottom right of the photo? Is that not right? --- End quote --- One pin *looked* orange at first, but it is yellow (quadrature) with a red outline (selected pin). The selected pin settings appear to be right. Is the other quadrature pin (6?) configured the same? (Mouse, X) Have you tried reprogramming the board? Scott --- End quote --- Yes but ticked reverse. |
| BadMouth:
I was just thinking along the same lines (because I've run out of other ideas) You need to have 2 pins configured as x-axis and in mouse mode. They must both be connected to the encoder at the same time or it isn't going to do anything. |
| MartinJames:
As replied above. It does it automatically. Striking either pin to ground affects the mouse cursor. just doesn nothing on the encoder. bloody thing |
| BadMouth:
Just to humor us, do a screen grab with the other quadrature pin highlighted. If nothing comes of that, time to email Andy at Ultimarc if he doesn't show up in this thread. |
| Navigation |
| Message Index |
| Next page |
| Previous page |