| Main > Main Forum |
| Help with 360 wheel encoder to UHID |
| << < (3/5) > >> |
| PL1:
Unless I'm missing something, the problem appears to be that you only have one quadrature input (yellow) on the UHID. One pin should be orange (5v) One should be blue (ground) Two should be yellow (Quadrature inputs) Scott Edit: D'oh! Before I zoomed in to confirm, the red outline and yellow blended to look like orange. *cleans glasses* |
| MartinJames:
--- Quote from: PL1 on April 24, 2013, 01:53:45 pm ---Unless I'm missing something, the problem appears to be that you only have one quadrature input (yellow) on the UHID. One pin should be orange (5v) One should be blue (ground) Two should be yellow (Quadrature inputs) Scott Edit: D'oh! Before I zoomed in to confirm, the red outline and yellow blended to look like orange. *cleans glasses* --- End quote --- Bottom right of the photo? Is that not right? |
| MartinJames:
I guess my question is, when I strike the ground and a mouse x pin the mouse jumps left. When I strike a mouse x and 5v it does nothing. is that right? Can the Uhid see this output from this encoder that is pulsing 5v? |
| BadMouth:
--- Quote from: vtivti on April 24, 2013, 02:11:49 pm ---I guess my question is, when I strike the ground and a mouse x pin the mouse jumps left. When I strike a mouse x and 5v it does nothing. is that right? Can the Uhid see this output from this encoder that is pulsing 5v? --- End quote --- You're not going to be able to duplicate the output of the encoder sufficiently for it to do anything. These aren't simple left and right signals. I'd refrain from jumping the pins. If the UHID mouse x pin is putting out 5v, it probably isn't configured right. |
| PL1:
--- Quote from: vtivti on April 24, 2013, 02:08:48 pm ---Bottom right of the photo? Is that not right? --- End quote --- One pin *looked* orange at first, but it is yellow (quadrature) with a red outline (selected pin). The selected pin settings appear to be right. Is the other quadrature pin (6?) configured the same? (Mouse, X) Have you tried reprogramming the board? Scott |
| Navigation |
| Message Index |
| Next page |
| Previous page |