Main > Woodworking

XArcade Dual Joystick Pedestal Plans

<< < (4/4)

Moksi:
Did a little job on the bezel, i am planning to cut out some laminate to cover the sides behind the plexi

Moksi:
used some laminate cut to cover the sides of the tv

Moksi:
final result with the plexiglass in front of the laminate

Moksi:
another look from the side , so the space around the tv is well covered, im basically done with it.

only behind the top part i need to fit a piece of wood to replace the large part that was there before i used it to cover it with the LCD in it.
will post some stuff again when i place it over at my place

Navigation

[0] Message Index

[*] Previous page