Main > Main Forum
Wiring question
Pages: (1/1)
Gatt:
Hi all,
I'm getting ready to upgrade my modular control panel, and switch to Electric Ice 2 buttons with RGB connectors. The issue I'm facing, if I understand the wiring right, is that each button would have 3 wires + ground, leaving me with needing to use 4 keystone jacks for each 7 button panel just for lighting.
I remember reading here about people using molex connectors for modular implementations, and was thinking of using a single molex connector with 22 pins for lighting so that I end up with one connector for lighting and one for the switches. Is this possible and advisable? If so, any suggestions where I might find a connector?
Thanks!
Nephasth:
Yup. Check out the wiring in the TwoHeaded Beast. I prefer Molex Micro-fit connectors.
Gatt:
--- Quote from: Nephasth on March 20, 2013, 09:19:28 pm ---Yup. Check out the wiring in the TwoHeaded Beast. I prefer Molex Micro-fit connectors.
--- End quote ---
That's an absolutely amazing cabinet!
Any suggestions on where to pick up those 24 pin micro-fit? I tried google but all I'm seeing are ones with fewer pins :(
Nephasth:
Molex.com. request some samples and don't forget the terminal pins.
Pages: (1/1)