Main > Main Forum

Wiring Cocktail Start Button to iPAC

Pages: (1/1)

jdbailey1206:

Quick question.  Just wondering if I can wire this http://www.twistedquarter.com/index.php?main_page=product_info&products_id=187 to this
http://www.ultimarc.com/ipac1.html

Thanks in advance for all the input.   

Nephasth:

Yep. Switches are switches, and wires are wires. It all makes a ciruit. I see three terminals on the switch, if they're labelled wire the NO contact to the IPAC and the COM contact to ground. But one terminal might be for an LED, hard to tell without a spec sheet.

kahlid74:


--- Quote from: Nephasth on March 19, 2013, 09:00:24 am ---Yep. Switches are switches, and wires are wires. It all makes a ciruit. I see three terminals on the switch, if they're labelled wire the NO contact to the IPAC and the COM contact to ground. But one terminal might be for an LED, hard to tell without a spec sheet.

--- End quote ---

Nephasth is right on the money but if this is an LED make sure you understand the voltage required.  They can be tricky and I thought the iPac can only handle 5v.  If that button requires 12volt you might want to reach out to Andy W. on the iPac before terminating it into there.

Pages: (1/1)

Go to full version