| Main > Main Forum |
| Coin Mechanism - will it fit? |
| << < (2/4) > >> |
| Richardgregory:
Forgot to ask: the picture makes the mech look quite large....do you think you can let me know what the height and how deep it extends in inches? Sorry, but an arcade builder newbie! :) |
| Unstupid:
It's not so much a retaining screw as it is a movable tab. The tabs will slide into the little recesses on your coin door and you will lock it into place with the gray metal hooks. The coin mechanism is 4" high by 3.5" wide. I tried to line it up with your photo like so: |
| Richardgregory:
That is superhelpful n' cool! THANKS again so much for helping out a newbie :) Heh...nice special effect that you did with your monitor and the mechanism !!!! - appreciate it Now I can go ahead and shop. Thanks again :D |
| Richardgregory:
I was looking at coin mechs today and well the guy said that in my existing coin door there has to be the Ground/Switch connection. As you can see by my pictures, there's no such thing :( So what are my options in getting a coin door wired up if this is the case? Thanks |
| MTPPC:
You are missing the part that goes under the mech outlet where the microswitch is. I don't know exactly what kind of coin door you have there, but you can probably look at some ebay photos and find the answers you are looking for. With any luck, you can just buy an entire coin door assembly and transplant the parts you need. |
| Navigation |
| Message Index |
| Next page |
| Previous page |