Main > Main Forum
Mini-Pac help - multiple buttons firing at once?
<< < (2/3) > >>
benarcade:
all 3 keypresses assigned to 13, all 3 to 14, and all 3 to 16

Yes, that is my problem.

The Mini-Pac is not connected to any buttons - it's a single wire from Ground to pin that registers multiple button presses in WinIPAC.

PL1:
If "A S Q" is showing up in all three boxes of table view of WinIPac, click on "restore defaults".

Once you restore defaults, the highlighted boxes should show up like in the attached photo.


Scott

EDIT: Forgot to attach the pic.   :embarassed:
benarcade:

--- Quote from: PL1 on March 05, 2013, 04:43:00 pm ---click on "restore defaults"
--- End quote ---

Thanks for the suggestion. It didn't work though. Still showing W + S + Q on those three pins.
PL1:
Sorry about forgetting to attach the pic earlier.

If WinIPac displays what the pic shows and shorting a single wire (disconnect the IDE cable first) from ground to one of the inputs gives all 3 outputs, you should contact Andy at Ultimarc.

Also, did you ohm out the wires to verify they aren't shorted?

That is far more likely than a bad Mini-Pac.


Scott
benarcade:

--- Quote from: PL1 on March 05, 2013, 09:26:20 pm ---If WinIPac displays what the pic shows
--- End quote ---

Thanks, Scott. That's exactly what it looks like.

And I'm using a bare Mini-Pac, 2 days old, connected to the computer via USB, ONE single wire between ground and pin 13 - or the others - and it lights up S Q W in table view.

In fact, here's the screen shot from pin 13:



I have an email out to Andy.

Thanks again.
Navigation
Message Index
Next page
Previous page

Go to full version