Main > Main Forum

Change buttons to Normally Open?

Pages: (1/2) > >>

007craft:

So I went and bought some push buttons for my arcade.  They are tiny buttons which I will be using for emulator functions.  Unfortunately, I already drilled holes and put them in my cab only to find out they are Normally closed buttons.  Is there anyway I can convert them to normally open?

Nephasth:

What buttons? Link? Pics?

007craft:

Umm, I bought them at a local store.

http://www.leeselectronic.com/index.php?id_product=3277&controller=product

Theres no pics but not sure why that would matter?  they are NC switches with 2 prongs and I want to make them NO switches

Nephasth:


--- Quote from: 007craft on February 11, 2013, 05:59:10 pm ---Theres no pics but not sure why that would matter?

--- End quote ---

There's thousands of different types of switches. How the ---fudgesicle--- am I supposed to know what one you have without a detailed description or a pic?


--- Quote from: 007craft on February 11, 2013, 05:59:10 pm ---they are NC switches with 2 prongs and I want to make them NO switches

--- End quote ---

If there are only 2 prongs (terminals) on the switch and it is NC... go buy new switches.

Dawgz Rule:

Because it is a two prong, you are pretty much out of luck.  Your best bet is to simply swap them out with the equivalent "normally open".  Check the part numbers and you will typically see an "NC" or "NO" to indicate what the normal position is.  You may also find it in the description.  Look at the bright side....it was a relatively inexpensive mistake.

Pages: (1/2) > >>

Go to full version