Arcade Collecting > Merit/JVL Touchscreen
ECS ION Motherboard Boot Error
mahkeymike:
--- Quote from: lilshawn on February 12, 2013, 10:35:56 am ---the one i found to replace Purple death, (Asus A7N8X-VM) is the same size and everything.
i just used a pair of tin snips to make a small cut-out in the I/O bracket because the power connector is in a different spot. (middle of the board.)
I had a bit of an issue with the audio not working at first, but i just booted up the machine with the old drive. Re-installing the software got it working again.
--- End quote ---
Ive used the A7N8X-VM aswell, but linux/centos fails to load lm-sensors for the ITE io chip because the linux/centos script is expecting the winbond io chip. So during loading you will see [FAILED]
Unless you manually replace the script :cheers: >:D
lilshawn:
--- Quote from: mahkeymike on February 12, 2013, 10:56:56 am ---
--- Quote from: lilshawn on February 12, 2013, 10:35:56 am ---the one i found to replace Purple death, (Asus A7N8X-VM) is the same size and everything.
i just used a pair of tin snips to make a small cut-out in the I/O bracket because the power connector is in a different spot. (middle of the board.)
I had a bit of an issue with the audio not working at first, but i just booted up the machine with the old drive. Re-installing the software got it working again.
--- End quote ---
Ive used the A7N8X-VM aswell, but linux/centos fails to load lm-sensors for the ITE io chip because the linux/centos script is expecting the winbond io chip. So during loading you will see [FAILED]
Unless you manually replace the script :cheers: >:D
--- End quote ---
Yeah, not a big deal though...The damn system doesn't track any of the temps voltages or RPM's anyways. (nice if it did and shut down when overheated.)
mahkeymike:
--- Quote from: lilshawn on February 12, 2013, 12:20:47 pm ---
Yeah, not a big deal though...The damn system doesn't track any of the temps voltages or RPM's anyways. (nice if it did and shut down when overheated.)
--- End quote ---
Yeah I know, I just dont like seeing [FAILED] everytime the system booted up. Its not hard to edit the script/module and add "it87" to get rid of it.
smartbomb2084:
So this board works 100% with no glitches even with the 'failed' loading error?
mahkeymike:
--- Quote from: smartbomb2084 on February 13, 2013, 08:56:12 am ---So this board works 100% with no glitches even with the 'failed' loading error?
--- End quote ---
I never noticed any problems. Its not going to be a direct fit into your ion evo cab though.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version