| Main > Main Forum |
| Noob looking for some help hooking up ledwiz to buttons. |
| (1/3) > >> |
| briscos horse:
I have a few BLUE CONVEX LED LIGHTED ARCADE PUSHBUTTONS From Paradisearcade and I would like to connect hem to the Ledwiz. I have looked all over and I have not been ble to find simple instructions. The LEDs have 2 connectors. Where do they go? Does one go to the led wiz if so which one and where? I have started trial and error but I don't want to fry the board or LED. Thank you |
| Furry131:
http://groovygamegear.com/PDF/LEDWIZ_INSTALL.pdf this should answer a bunch of your questions. |
| briscos horse:
I used that doc to hook up the first led I tried and it did not light up. Not sure if I need to running the software on the pc that is connected to it before trying to make it light? Thanks |
| RandyT:
--- Quote from: briscos horse on February 05, 2013, 03:46:22 pm ---I used that doc to hook up the first led I tried and it did not light up. Not sure if I need to running the software on the pc that is connected to it before trying to make it light? --- End quote --- Yes, that is what will be controlling the LED. You can test the connection by holding a wire against the metal USB shell, and touching the terminal screw. If it lights like that, then it will light for your software. |
| briscos horse:
I installed the led wiz software the led didnt light up. There are 2 wires coming from the led which on do i touch the usb shell with? Also which terminal screw do i use for the other one? |
| Navigation |
| Message Index |
| Next page |