Arcade Collecting > Pinball

Help with couple problems with Stern Nine Ball restoration (RESOLVED)

<< < (2/2)

arzoo:

--- Quote from: ChadTower on January 28, 2013, 09:01:08 am ---
That happens a lot.  The cheapo tabs break on those caps and people glue them back on.  In the long run it's best to replace those broken caps in a restoration.  Fortunately this one isn't a super expensive one like in a Fathom or Xenon.

When you say "traced it back and the switch wire is fine" do you mean to say you checked continuity or you eyeballed it?

--- End quote ---

Yes - I had traced it all back. Turns out there was a short, so the switch was in the closed position as far as the MPU was concerned. Thanks, for the help.

ChadTower:

Could you provide details on the short so the solution sits in the same thread as the question?

Navigation

[0] Message Index

[*] Previous page