Main > Main Forum

Bill Acceptor help needed

Pages: << < (2/2)

ed12:

hi
there is more to this then meet's the eye
but let's get the basic down first
and i can help u 100%
they are calling twian for me

Ed,
 
To recap our phone conversation, please inquire as to the following from
your
customer...
 
1) Which interface is he going to be using on his vending machine?
2) Which denomination notes does he need to be able to accept?
3) Has there been any re-designs on the Pakistan Rupee currency
      in the last several years? Size changes or material changes in the
      notes themselves?
 
I'm trying to figure out why the validator will accept newer notes but not
older ones. Are older notes going out of circulation? How important is
it to be able to accept the older notes?
 
Thank you
 
Scott Parker

so u can clearly see we need these basic answer's
then i will get the tech stuff for u
the fp001 may not be what u need,as your country and china had a wack of different protocol's where fp001 is set up for mdba
yours may be totaly different

ed


zaaid1989:

Dear ed, first of all billions of thanks for all this help. I am really thankful to you.

Ok, I will ask them for fp001 programmer and the alignment card. I have already downloaded the manual.

Ummm ed, As I mentioned I haven't tested the bill acceptor myself so I am not sure about the answers of these questions. Can you suggest me someway to test it with some currency?

According to my friend; the bill acceptor is designed for Pakistan's currency. There haven't been much changes in the currency notes design but the notes are made of paper like material and older ones usually get really rough.

But I must mention here that by "older notes" I mean the notes that have been used for some time and have gotten rough/dirty. Not old in sense of design.

I haven't researched anything about interface. My first concern is to make bill acceptor work first. It is the most important thing.

Thank you again for the help. The forum has proved to be much much more helpful than my expectations.

Zaaid

ed12:

hi
there realy olny 1 thing that we need to do first
do u have a variable power supply? it must be good to 2 amp's
and 0-36vdc
i can lay out a interface for u if it is a dc unit?
reason for 2 amp's is the stacker will peak at that
now can u send or post a clear pic. of this unit ?
both side's,and i can and will guide u the rest of the way
i will foward your reply to me to ict,where they can better help both of us,
hang in there

ed

Pages: << < (2/2)

Go to full version