Main > Main Forum
Simple removable control panels
spystyle:
I agree that using an encoder for each panel is a waste of $25 or more.
However, I am convinced it's the most simple. Especially if USB encoders are used. But I might try using a single encoder next time :)
Regardless, I hope I was able to contribute - if nothing else, a base concept others can improve upon.
As for magnets, hard drive magnets are extra strong ... that just might work :)
Maybe it's possible with "countersunk neodymium ring magnets"
eBay Link :
http://www.ebay.com/sch/i.html?_odkw=neodymium+ring+magnets&LH_BIN=1&_osacat=0&_from=R40&_trksid=p2045573.m570.l1313&_nkw=countersunk+neodymium+ring+magnets&_sacat=0
Cheers,
Craig
paigeoliver:
Strong magnets on the control panel would wreck havoc with a crt screen.
--- Quote from: spystyle on December 15, 2012, 07:54:49 pm ---As for magnets, hard drive magnets are extra strong ... that just might work :)
Cheers,
Craig
--- End quote ---
spystyle:
Yeah truly, the magnets would have to be spaced or bucked properly.
In the meantime, I find this a very simple way to go :)
Minwah:
For my swappable panels I have one (PS/2) IPAC in the cabinet. The panel controls connect with molex connectors.
Also I put the latches on the inside...bit harder to get to but only takes a minute or two to swap panels.
rCadeGaming:
--- Quote from: spystyle on December 15, 2012, 07:54:49 pm ---I agree that using an encoder for each panel is a waste of $25 or more.
However, I am convinced it's the most simple.
--- End quote ---
Sorry, but if you're still convinced of this, you're not grasping my or Minwah's post. You're wasting your money.