Main > Main Forum
Help. Can't get 60 in 1 to work with my CGA monitor.
<< < (3/3)
mgb:

--- Quote from: TOK on December 15, 2012, 09:41:09 am ---The one other thing I suggest reading up on is positive and negative sync. Not sure what monitor you're running, or about the rest of your setup because Phoenix wasn't JAMMA.

http://arcadecontrols.com/BBBB/sync.html

--- End quote ---

+1 on this.
the sync may not be hooked up right. the 60 in 1 is a jamma board so it uses negative composite sync. you may need to jump both the H and V sync connectors at the monitor connector.
also not sure what monitor you have, but I'm guessing maybe an Electrohome g07 (but it could be any)
Navigation
Message Index
Previous page

Go to full version