| Main > Project Announcements |
| crosbred900's Analog Xbox360 Control Panel - DONE! |
| << < (8/8) |
| theskid31:
--- Quote from: BadMouth on January 19, 2013, 10:19:23 am ---The outlines on these sheets are slightly larger than the inserts in Seimitsu buttons. The smaller circles inside the bottom row are for 24mm buttons. At 300dpi, these should print the correct size if you uncheck "fit picture to frame" in the stupid windows photo helper thing. They did for me anyway. Your mileage may vary, use at your own risk, etc. Here is the method I used to apply them, but I'm sure there are other ways to go about it. 1. Print on an Avery 18665 full sheet clear label. 2. Cut them into smaller, more manageable pieces containing four labels. 3. Placed them face down and peel the backing off. 4. Carefully place a Semitsu insert in the center of each circle. 5. Cut them apart so you can work with one at a time. 6. Using a fresh x-acto blade, trim around the edge of the insert, removing the circle you used as a guide. --- End quote --- Hi what are the settings to print these in windows 10’s photo viewer as they seem to come out too small Thanks |
| Lingwendil:
Just wanted to bump this thread with additional labels I made, since this is one of the few useful threads that comes up when searching for button labels. I added some new ones for Playstation specific symbols and a few extras for general use. I have confirmed that it still prints true to size. This thread was a huge help for me so I just wanted to pass these along. |
| Navigation |
| Message Index |
| Previous page |