Main > Project Announcements

Atari Stun Runner restoration

<< < (3/3)

BC_Jeffro:
went to the shop to paint a cab that im fixing for friend, had a dead WG4600 swapped it for a acer 4:3 19 inch used a converter board, the picture looks great from all angles and bright even under the smoked plexi.
so i was waiting to put the 3d coat so i inspected the Atari yolk controller and found some serials
- the cover plate and the controller don't match
- the pins that go with the 2 Allan key bolts on the handle were loose inside and there is no hole for them in the handle pieces, iv seen picture of them and there is 3 holes and the pin in in the middle one so i don't know?

PL1:
What the heck??  ???

042634-01 is the part number for the rear frame on the Stun Runner yoke (the part that bolts to the cab)  See pg 40 of the manual. (SW yoke uses an A040236-01)

The picture above shows 042634-01 painted on the front frame. (the part that turns)

Front frame on Stun Runner and SW should be P/N A040247-01 (mine is painted on the inside under the spring)

The crosspiece looks different from the one shown on pg 39.

Hmm. . . . Curiouser and curiouser.

Some handles only had the two screw holes like your picture above shows, with no hole for the roll pin mentioned in the manual.  The screw holes are spaced the same on both versions.


Scott

Navigation

[0] Message Index

[*] Previous page